profilan® is the professional program for protecting and finishing wood for indoor and outdoor use.
With our coordinated systems of primers, glazes and opaque paints, no design wishes remain unfulfilled. The demand on our products is clear: the highest processing quality, convincing results and optimal protection! We implement these goals in our own research and development department with new ideas and products for you when it comes to wood protection, surface systems and care.
Applications
Airless spraying
Airless is an airless atomising paint spraying process in which, in contrast to air atomisation (Airmix), the material is atomised solely via the material pressure. In this process, the material is pressurised by an electrically or pneumatically operated pump and presses the material through a nozzle bore at up to 250 bar. There, the material is split into a spray jet.
Airmix process
In the Airmix process, the additional air is fed into the spray jet via the nozzle slope before the paint emerges. This guarantees a quiet, stable spray jet and uniform paint application. This means that lower pressures are required.
Flooding
Rational, material-saving application process for primers and intermediate coatings. In special flooding systems, wooden components are sprayed with excess by means of conveyor systems, primarily in closed circuits.
Dipping
Particularly rational application method for primers and intermediate coatings, which is almost loss-free due to special dipping tubs, with usually manual handling of the individual wooden components.
Vakumat
Loss- and overspray-free, profile-independent vacuum coating of profile elements and surfaces. Excess paint is applied in a housing that is closed on all sides, and is evenly extracted again by generating a vacuum. A variety of coating media and layer thicknesses can be used by changing the suction strength. Precise all-round and segmental coating is possible in a single operation. High-quality surfaces are achieved. Depending on the coating system, layer thicknesses of 10 to 200 µ/m² can be achieved. Extremely high production speeds can also be achieved.
Brush
This simplest form of protective treatment is mainly used by do-it-yourselfers. In the commercial sector, the painting method is only considered in special cases due to the cost and time involved, such as the treatment of large components (e.g. glulam) or the post-protection of fresh interfaces. In order to achieve the required application quantities, several work steps are usually necessary.
ESTA
In electrostatically assisted coating, atomisation takes place via the airmix or airless process. In addition, there is a repulsion effect due to the same-pole charging of the material droplets, which can considerably refine the spray pattern. The charged droplets try to discharge themselves on a grounded object. This creates an attractive force of the droplets to the grounded workpiece. According to the ratio of attraction effect and droplet acceleration, the application efficiency can be significantly improved by this technique. Under ideal conditions, an application efficiency of up to 90 % can be achieved.
